SATO CT 412i, Руководство оператора

Страница: 48 / 73

Unit 4: Printer Configuration
CT4i Operator’s Manual
4-11
4.4.3 Default Settings Mode ( FEED + POWER ON)
Turning the printer ON in this mode simply resets major settings to their default values. (See table). After
the default values have been restored, the printer emits three beeps. The ERROR LED also lights up
during the reset operation, but goes off after the settings have been activated.
Parameter Default Setting
Reference position Vertical: 0dot, Horizontal: 0dot
Pitch offset 0 dot
Cut position offset 0 dot
Dispensing position offset 0 dot
Tear off position offset 0 dot
Label size (Pitch, width) Pitch=3200 dot x width 832dot [8dots/mm]
Pitch=4800 dot x width 1248dot [12dots/mm]
Pitch=9600 dot x width 2496dot [23.6 dots/mm]
Print speed 100 mm/s [8dots/mm] [12dots/mm]
50 mm/s [23.6dots/mm]
Print darkness 3A [Direct thermal]
3B [Thermal transfer]
Sensor type Gap
Kanji character code JIS
Paper end detection means Roll type
Zero slash Enable
Proportional pitch Enable [CT Series]
Buzzer Enable
Initial feed Disable
Auto-feed Disable
Gap size 24dots [8dots/mm]
36dots [12dots/mm]
72dots [23.6dots/mm]
Optional operation modes Operation No. 1
VR (Potentiometer) Option stop position offset =0, print darkness=0
Interface settings IEEE1284: Multi buffer, ACK width =500ns
RS-232C: Baud rate=19200bps, Data-bit=8bit, Parity=off, Stop bit=1bit, Con-
trol=READY/BUSY control (multi- buffer)
LAN/Wireless LAN: Driver exclusive protocol (Status 4) cycle response mode (2-
port connection using Port 1024 and Port 1025, or 1 port connection using Port
9100.)
USB: (no default settings)
Bluetooth: Bluetooth mode = Status 4, PIN code = 0000000000000000, Authenti-
cation mode = Authentication Level 1, ISI=0800, ISW=0012, PSI=0800, PSW=0012,
Device name = SATO ONLINE PRINTER, CRC Check = Disable