User
Manual
GSM-4S
18
10.1 SMS
MESSAGES
The SMS messages to be transmitted can have standard contents or can be modified by the
user. The user's own message can be entered by using the module’s push-buttons or by
utilizing the SMS message sent from another telephone to the SIM300CZ telephone number.
The contents of messages are entered by special service mode functions (submenu
Messaging) or from the DLOAD10 program.
To change the contents of a standard message by using the module buttons, it is necessary
to follow the steps:
•
Initiate the service mode.
•
Go to submenu Messaging.
•
Select appropriate function for programming the contents of SMS message.
•
Read the present contents of the message, after recalling the selected functions. By using
push-buttons NEXT and CHANGE it is possible to enter your own contents of SMS
message regarding the event which corresponds with the function’s description.
•
Accept the introduced changes by pressing push-button OK, and proceed with
programming the next message, or abort the operation of service mode.
To enter the contents of the message by means of another cellular telephone, it is necessary
to follow the sequence:
•
After recalling the function for programming the contents of a message, simultaneously
press and hold push-buttons NEXT and CHANGE.
•
If the contents of present message are standard, the information "Read-out from SMS" will
be displayed on LCD display, and the module will go into "awaiting for SMS message
mode" for the duration of approx. 110 seconds.
•
Send SMS message (previously prepared) from another cellular telephone to the
SIM300CZ telephone number. The message to be sent should be of a special format.
The contents of the message, which is to be loaded into the module’s memory should be
put into brackets and closed by asterisks, as follows: (
¼
Contents of message
¼
).
Notes:
•
If, after recalling the function, the contents of the displayed message is not standard,
pressing and holding the push-button NEXT and CHANGE will cancel this message,
the next pressing will result in displaying the standard message and only the successive
pressing will make it possible to load the message by means of SMS message.
•
Both push-buttons must be pressed simultaneously, otherwise the module will enter the
mode for manual editing the message and it will be necessary to renew the procedure for
reading the message from SMS.
•
The length of the message stored in the module’s memory is limited to 32 characters.
The standard contents of the transmitted SMS messages are as follows:
"Input n violation"
"Input n restore"
"Phone line failure"
"Phone line restore"
"Test message"
10.2 V
OICE MESSAGING
If the SM-2 voice synthesizer with recorded voice message is connected to the module,
the violation of any input and its restoration or activation of output OT4 and its restoration can
initiate sending this message to the selected telephone numbers. When sending the
for inputs; where n = 1,2,3,4
for output OT4
