Satel CA-6-P, Руководство по установке

Страница: 28 / 36

26 SATEL Installer Manual
1. enable operation in the transmission format UTI V.21 (CCITT V.21) or BELL 103
(operation at a rate of 300Bps on telephone line),
2. permit operation to be configured only in one of these formats (the function of automatic
format negotiating disabled).
Before starting the first connection between the computer and the control panel,
appropriate settings must be entered in the DLOAD10 program (CONFIGURATION
window). Information on the modem configuration is contained in the DLOAD10 program
„HELP” file (function activated with F1 key), topic: “COMMUNICATION” and in chapter
PROGRAM CONFIGURATION FOR COMMUNICATION WITH THE PANEL
of this manual. In the case of
non-standard modems, you must refer to the modem manual for the information on
configuration procedures.
Interaction with the computer by means of a
modem can be effected in two ways: in
a remote mode (through the telephone line) or in a local mode . The local mode can be
used after connecting the modem directly to the TIP and RING telephone terminals on the
control panel (see: Fig. 14).
CA-6
control panel
telephone
connector
connector
synthesizer
to modem
resistor
220
(+12V)
(COM)
T-1
R-1
RING
TIP
Ω
mainboard
Fig. 14. Connecting control panel to modem for local mode programming.
Local communication:
•
connect the computer modem to the “TIP” and „RING” control panel terminals
( the telephone line must be disconnected! Connections of the “T-1” and „R-1”
terminals are irrelevant), and make sure that the polarity of the telephone signal inputs
arrangement in the control panel is as shown at the Fig. 14;
•
start the DLOAD10 program, select the CA6 control panel type (e.g. by opening the
data of such a panel) and, from the menu „ Communication ”, select “ Modem ” and
„local” or „CA-6 without keypad” connection mode. Further procedure will be prompted
by the program. The „CA-6 without keypad” command in the „Initializing modem”
window enables to automatically run the program from the computer with no need for
operating the control panel from keypad and calling the function FS112. This feature
can be disabled by the installer with software means, with the use of function FS131
(option 2);
•
program the communication passwords – communication passwords in the control
panel (FS2 and FS3) and in the alarm system computer data must be identical;
•
enable the „external downloading” option (FS5).
Note: When starting communication with the function FS112, make sure that the function
FS112 is only called when the modem starts sending signal to the control panel
-
there can be a few seconds lag in some modems.