ACCO
SATEL
49
−
the access schedule does not provide for granting permission to pass at that moment (3
long beeps);
−
the door is blocked (3 long beeps);
−
the user's defined entries limit is exceeded (3 long beeps);
−
the user is trying to get access at the terminal, from the side of which he has already
unlocked and opened the door (3 long beeps) – the A
NTI
-
PASSBACK
function is running;
−
the module operates in the sluice configuration and the other door is open (3 long beeps);
−
the terminal is blocked (1 very long beep) – the A
NTI
-
SCANNER
function (holding the card
by the authorized user for 3 seconds will unblock terminals).
Unlocking and opening the door by means of the terminal A will be registered as an
authorized entry (event: “Access granted – entry”), and by means of the terminal B as an
authorized exit (event: “Access granted – exit”). Cancellation of the door opening after being
granted access at the terminal A will be registered as cancellation of the entry (event:
“Access granted – entry. Door not opened.”), and after being granted access at the terminal
B – as cancellation of the exit (event: “Access aborted – exit. Door not opened.”). In case of
the access refusal, there will also be registered information on whether it was refusal of
permission to enter (terminal A), or refusal of permission to exit (terminal B).
7.1.2 Unlocking the door without user identification procedure
The door can be also unlocked, bypassing the access control procedures, by using the
module input programmed as the U
NLOCK BUTTON
. The input can be controlled by means of
the button or other device. Appearance of the control signal will unlock the door for the time
programmed as the A
CCESS TIME
(the time of the control signal being supplied to the input
has no effect on the door unlocked time).
7.2 Blocking the door
7.2.1 Blocking the door with the use of identifiers
The door can be blocked by the user having the S
WITCHING
authority. The user can only block
the door when he has access to the door, according to the access schedule.
Note:
If door status control is disabled, door can be blocked only by means of LCD keypad
and code.
In order to block the door by means of the proximity card, do the following:
1. Make sure that the door operates in normal mode and the door is closed.
2. Place the card in proximity of the reader and hold it for about 3 seconds – 2 short beeps
will confirm that the door is blocked.
Note:
If, according to the module settings, the user is to be identified in the LCD keypad /
keypad on the basis of card and code, or code only, then the function of blocking the
door by means of card will be unavailable in the keypad.
In order to block the door by using the code and LCD keypad, do the following:
1. Enter the code and confirm with the
key.
2. Scrolling through the menu by means of the
and
keys, find the Block door function.
3. Press the
or
key. 2 short beeps will confirm that the door is blocked.
