28
SATEL
ACCO
by means of the module search function or added manually) is displayed on the left-hand
side of the window. Displayed on the right are settings of the module selected the list.
7. Each new module must be registered so that the program can establish communication
with it and, consequently, to enable reading and writing the data. To register a single
module, use the R
EGISTER MODULE
command, available in the M
ODULE
menu. Provision is
made for registering all modules by means of the R
EGISTER ALL MODULES
command, also
available in the M
ODULE
menu.
Note:
During registration, the System identifier (the same that was defined in the New
configuration file window) is saved in the module. If a module which has a different
identifier (was registered in another system) is added to the system, registration of
such an identifier in the new system means deletion of all data and restoration of
default settings.
Fig. 22. The M
ODULES LIST
window with modules which are still unregistered.
8. Having registered the module, the program will automatically read data from it (this
applies to the modules with factory settings and the modules having a consistent identifier
of the system). You can proceed to configuring the module.
9. Having configured the module(s), save the new settings. The S
AVE
button in the modules
window enables saving the data to the selected module. The S
AVE
button available on the
program menu bar (see Fig. 21) makes it possible to save the data to all system modules
whose settings have been changed.
