Satchwell
Copyright © 2006, TAC AB
All brand names, trademarks and registered trademarks are
the property of their respective owners. Information contained
within this document is subject to change without notice. All
rights reserved.
TAC Headquarters
Malmö, Sweden
+46 40 38 68 50
Satchwell Helpline
+44 (0) 1753 611000
[email protected]
DS 10.154A
www.tac.com
03/06
DIMENSION DRAWING
Weights:
MN650 approx.
1000g
RTC Card approx. 6g
Cautions
•
Do not apply any voltages until a qualified technician has checked the
system and the commissioning procedures have been completed.
•
This is a 24Vac/dc device. Do not exceed rated voltage. Local wiring
regulations and usual safety precautions apply.
•
24Vac must be supplied by a transformer conforming to EN 61558.
•
If any equipment covers have to be removed during the installation of
this equipment, ensure that they are refitted after installation to
comply with UL and CE safety requirements.
•
Do not exceed the maximum ambient temperature.
•
Interference with parts under sealed covers invalidates guarantee.
•
Do not charge, short-circuit or solder the MN RTC battery. Do not
allow contact with water, nor heat, disassemble or dispose of in fire.
Do not reverse polarity in application.
•
The design and performance of TAC Satchwell equipment is subject
to improvement and therefore liable to alteration without notice.
•
Information is given for guidance only and TAC Satchwell does not
accept responsibility for the selection or installation of its products
unless information is given by the Company in writing relating to a
specific application.
•
All installation wiring must conform to BS 6701:2004 and EN 50174.
•
A periodic system and tuning check of the control system is
recommended. Please contact your local sales office for details.
