3
Mounting
Panel or DIN Rail Mounting
1.
Select mounting location. Allow minimum 150mm clearance
around controller.
2.
Do the following to mount controller on a panel:
a.
Loosen two screws securing terminal cover and remove cover.
b.
If not already fitted, press the wall mounting clip into the back
of the controller.
c.
Lift wall mounting bracket clip. (Located on top back of
controller.)
d.
Using a No. 10 self-starting screw, install top screw.
e.
Lift and level controller.
f.
Using two No. 10 self-starting screws, install bottom screws.
g.
Re-install terminal cover. (May be left off until wiring is
completed.)
3.
Do the following to mount controller on a DIN rail:
a.
While pulling down on DIN rail locking bracket, snap controller
base on a 35mm DIN mounting rail.
b.
Release DIN rail locking bracket.
Location
The controllers are suitable for indoor use only. When selecting a
mounting location, make certain the following conditions are met:
•
Do not install where excessive moisture, corrosive fumes, vibration,
or explosive vapours are present.
•
Do not install near large contactors, electrical machinery, Variable
Speed Drives (VSDs) or welding equipment.
•
Allow 150mm clearance from contactors, switches, and associated
cabling.
Locate where ambient temperatures do not exceed 50°C or fall below
0°C and relative humidity does not exceed 95% or fall below 5%,
non-condensing.
MOUNTING METHODS
Panel Mounting
DIN Rail Mounting
