SATA AE5801, Руководство пользователя

Страница: 27 / 136

27
ES PT JA RU EN DE KO
中文
AE5801/AE5802/AE5803
Fault symptom Possible causes Solutions
Output air volume increased or
low pressure 1. Required air volume greater than rated value
2. Intake filter blocked
3. Valve plate with carbon deposit or stuck by
foreign matter
4. Loose valve seat or damaged gasket
5. Valve wear or spring failure
6. Piston ring or cylinder wall broken
7. Too low speed
8. Leakage at the exhaust pipe or joint 1 U s e a n a i r c o m p r e s s o r w i t h a l a r g e r
horsepower to replace the current one.
2. Clean the filter element or replace it with a
new one.
3 Remove and clean it.
4. Tighten the valve seat or replace the gasket.
5. Replace it with a new one.
6. Replace it with a new one.
7. Adjust the belt tension or replace it with a new
one.
8. Check the pipe or joint with soapy water and
tighten it.
Too high pressure or a sound
from the safety valve 1. The set output pressure greater than rated
pressure.
2. Pressure switch or relief valve damaged.
3. Too low set pressure or damage of safety
valve. 1. Adjust the pressure setting.
2. Replace it with a new one.
3. Adjust the pressure or replace it with a new
one.
Oil in the air or too high oil
consumption 1. Excessive oil.
2. Oil ring installed incorrectly or worn
3. Oil with improper viscosity used.
4. Piston ring or cylinder wall broken.
5. Air vent blocked. 1. Adjust the oil level.
2. Replace it.
3. Change to the correct lubricating oil.
4. Replace it with a new one.
5. Clear the blockage.
Excessive vibration of
compressor 1. Too high operating pressure.
2. Pulley not aligned or loose.
3. Unstable foundation. 1. Reduce the operating pressure.
2. Adjust or tighten it.
3. Shim or fix it.
Loud sound during rotation 1. Loose valve seat.
2. Cylinder head impacted by piston.
3. Connecting rod bearing alloy worn.
4. Bearing bush broken. 1. Tighten the valve seat.
2. Install a thicker gasket.
3. Renew the bearing alloy.
4. Replace the bearing bush.
Overheat of compressor parts 1. Incorrect direction of rotation, no heat
dissipation.
2. Too high operating pressure.
3. Insufficient or improper lubricating oil.
4. Too high ambient temperature or poor
ventilation.
1. Change the wiring.
2. Reduce the operating pressure.
3. Change to the correct lubricating oil.
4. Change to a well ventilated place.
X. Causes and solutions of air compressor failure
AE5801八国-200621.indd 27 AE5801八国-200621.indd 27 2020/6/23 19:08:32 2020/6/23 19:08:32