27
Stand 07/2022 IR
CAUTION: DANGER OF CUTTING WHEN HANDLING THE WORK DISCS!
ATTENTION: The hinge bar on the left of the appliance must be correctly threaded into
the fixtures, otherwise the lid will fall. To remove a working disc that may already be
attached: To do this, turn the working disc to the left out of the adjustment at the
edges, then remove it upwards.
CAUTION: DO NOT REACH FOR THE KNIVES! DANGER OF CUTTING!
Remove an ejector disc (plastic disc) that may already be attached: To do this, pull the
ejector disc straight upwards at the central inner bulge, no adjustment, please do not
tilt it.
Now you can start cleaning.
By removing the hinge bar, on the left of the appliance, the appliance lid
can be removed for easier cleaning if necessary. Then thread it back in
and turn the bracket of the hinge bar downwards so that you cannot get
caught on it.
INSERTING THE DISCS
Check that the appliance is standing securely on a dry, non-hot, non-slip
surface.
• Select the working discs as required:
Cutting disc 2, 4, 6, 8, 10 mm or
Grating disc 2, 3, 4,5, 7 mm or
Strip disc (julienne) 3 x 3 mm, 4 x 4 mm or
French fries creel 8 mm, 10 mm or
(in combination with corresponding cutting disc!)
Cube creel 8 x 8 mm, 10 x 10 mm
(in combination with corresponding cutting disc!)
• Check that the hinge bar is correctly seated on the left side of the unit. The hinge rod must be correctly
threaded into the fixtures, otherwise the lid will fall.
• Open the appliance lid on the front of the appliance by pressing the rectangular rocker on the bottom right
of the appliance.
Open the unit and swing it open to the left.
