Sanyo SPW-W366HH58, Руководство по установке

Страница: 12 / 38

12
GB
E) Pilot wire for electric convectors (if any)
- The pilot wire sends shut-down, " anti-freeze " (long term absence) or " Economy " mode instructions to the electric
convectors in zone 2, and possibly in the case of 1 floor zone or 1 terminal unit zone applications.
Convector control (not supplied) must be adapted to receive this type of signal (standard GIFAM 4).
Consult the manual of the electric convectors.
- 230 VAC signal from the heating board.
- 1.5 mm
2 single-pole cable adapted for the operating voltage.
- Max. number of convectors controlled by the pilot wire: 20.
- To be connected to the heating board A1 .
- Note:
The electrical power supplied to the convectors must be the same as that of the module.
F) ECO signal for remote controls (if installed)
- In order to send reduced mode orders ( Eco or standby ) to the terminal unit remote control units in the case of
applications such as 1 terminal unit zone or 2 mixed zones.
- In the form of a potential-free contact which can used in VLV (Very Low Voltage), 2A max.
- To be connected to the heating board
A1
.
- Note:
The contact can control up to 10 RCC10 ( 70250051 ) or RCC20 ( 70250052 ) type controls.
Consult the terminal unit and remote control documentation to connect this contact.
CONTROL PART CONNECTION DIAGRAM
- Route the control cables on the right side of the board.
- Pass the pilot wire (230 V) on the left side of the board.
1 2
CN1
230V
CN2 CN3 CN4
CN8 CN7 CN6 CN5
3
5 43 2 1 43 2 1 4 5 3 21 3 21
NU FP R1 R2 R3 C E1 E2 T+
H1 A1 C A2 C 4 32 1 S1 C S2 C S3 A3 H2 H3
T- D1 D2 +-
1 23 4 123 4 123 4
F D B
A
C
A1
Q4
NU
Q1
NU
Q2
NU
Q3
NU
KM1 KM2 KM3 KM4
KA1 KA2
U1 U2
12
R1 R2 +
E
Pilot wire
Electric
convectors
(if any)
ECO signal
(if any)
Electrical
utility
meter
Load shedding
(if installed)
Control unit
BUS connection to
the 2-zone module,
ATK-WM2ZF or
ATK-WM2ZM
(if any).
OR
Outside
temperature
sensor
Heating
board
Power terminal strip XA
Control terminal strip XB
To Outdoor
Unit
Keypad / RCS -
TM80 BG display
unit (if any)