Remote Control Unit (continued)
SET button
After using the TIMER ON button or TIMER OFF button to set the
timer, use the Back/Forward buttons to enter the time, and then
press the SET button.
CANCEL button
Press this button to cancel the current timer setting.
SAVE button
This button fixes the temperature setting to allow energy-conserving
operation friendly to the environment.
CLOCK button
Press this button to set the current time.
MODE selector button
(AUTO)
(DRY)
(COOL)
Use this button to select the AUTO, DRY or COOL mode.
: The
air
conditioner
automatically
selects
the
type
of
operation (DRY, COOL) suitable for the particular room
environment.
: The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
FLAP button
To change the airflow direction up or down, hold down the FLAP
button during operation. The unit makes a beeping sound and then
starts to move.
: The airflow direction is set automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
NOTE
To switch to the sweep function (
) when in the manual ( ) mode,
hold down the FLAP button.
FAN SPEED selector
button
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
1 HR. TIMER button
(1-HOUR OFF TIMER)
: When you press this button, regardless of whether the unit is
operating or stopping, the unit operates for one hour and
then shuts down.
Reset (
) button
(ALL CLEAR)
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
A/C SENSOR button
When you press this button (use a small-tipped object such as a
ballpoint pen), the
mark will appear at the display. And the room
temperature is detected by the sensor which is built into the indoor
unit and the air conditioner is controlled accordingly.
NOTE
If the remote control is located near a heat source, such as a space
heater or in direct sunlight, press the A/C SENSOR button to switch
to the sensor on the indoor unit.
ADDRESS switch
•
The address switch changes to prevent mixing of signals from
remote control units when two Sanyo air conditioners are installed
next to each other. Normally, the address switch is set to A. When
switching the address, the remote control must be changed, and
the jumper cables on the indoor unit board must be switched. For
more information, please contact the dealer where you made the
purchase.
•
Normally, the tabs on the remote control unit should not bent.
NOTE
The remote control unit sends the temperature signal to the air conditioner regularly at five
minute intervals. If the signal from the remote control unit stops for more than seventeen
minutes due to the loss of the remote control unit or other trouble, the air conditioner will
switch to the temperature sensor which is built into the indoor unit and control the room
temperature. In these cases, the temperature around the remote control unit may differ from
the temperature detected at the air conditioner’s position.
9
OI-306-09EG
oi306000
