Sanyo PLV-HD10, Руководство по обслуживанию

Страница: 28 / 178

- 28 -
Holder Power
Power Board
C
C
C
C
Power unit
B
B
A
A
5
-7
Current sensor removal and replacement.
Power unit
Ass'y Power unit
K6A
Current sensor
Current
sensor
K
L
K96W
Inter lock switch
SW902
Unhook
Blue lead wire
Blue lead wire
K6A
SW902
(a)
Printed mark
A903
1. Unhook the part(a) and remove the current sensor.
Note:The way of installing a current sensor is very important on the performance and the safety. Install in the
condition which is the same as the time of disassemble.
Replacement
1. The Current sensor is attached in the blue lead wire between an interlock switch (SW902) and power unit
(K6A).
2. The Current sensor (L) side is attached in the k6a side.
Refer to schematic diagrams (page-S1).
PWB units may be reassembled in the same location and direction from which they were removed. Be careful of the
attached direction of PWB units.
Power Unit removal.
Power Unit removal.
1. Remove 2 screws-A, remove 2 screws-B and remove the Power Unit.
2. Remove 4 screws-C and remove the Power Board.
(See Fig.5-7, 5-7a)
Fig.5-7b
Fig.5-7a
Fig.5-7
Mechanical disassemblies