Sanyo PLV-HD10, Руководство по обслуживанию

Страница: 109 / 178

- 109 -
-- Unit-Sub power --
■
Incase this unit is fault, replace the unit completely,
do not replace the individual component.
Readjust the following adjustment item.
2. +25V voltage adjustment.
3. Fans driving voltage adjustments.
Parts list
Safety significant parts
Product safety should be considered when a component replacement is made in any area of the projector.
Components indicated by mark ( ) in the parts list and the schematic diagram designate components in which safety can
be of special significance. It is, therefore, particularly recommended that the replacement of the parts must be made by
exactly the same parts.
■
Readjustments after parts replacement.
Note:
Do not replace or order resistor and capacitor following the
specifications shown in the schematic diagrams. Always
check for the correct specifications in the parts list. Part
order must contain Chassis No., Part No., and descrip-
tions.
Give complete “CHASSIS NO." for parts order or serv-
icing, it is shown on the rating sheet on the cabinet of
the Projector.
-- Assembly Power --
■
When it is replaced to the new assembly power.
Factory adjustment of the new assembly power has com-
pleted. Readjustment is unnecessary.
■
When the component parts of assembly-power are
replaced.
Readjust the following adjustment item.
1. +6V voltage adjustment.
Electrical adjustment
■
Readjustments required after Parts Replacement
After replacing electric parts and optical parts, electric readjustment and optical readjustment are required.
Rating sheet
Displayed Model No.
and Chassis No.
-- Unit-lamp-ballast --
■
In case this unit is fault, replace the unit completely,
do not replace the individual component.
Readjustment is unnecessary.
-- Unit-PFC. --
■
In case this unit is fault, replace the unit completely, do
not replace the individual component. Readjustment
is unnecessary.