Sanyo PLV-55WM1, Руководство пользователя

Страница: 44 / 60

44
Setting
This function is used to reset the Lamp replace counter. When
replacing the projection lamp, reset the Lamp replace counter by
using this function. See page 48 for operation.
Lamp counter reset
Factory default
This function returns all setting values except for the lamp counter to
the factory default settings.
Select Factory
default and this box
appears. Select
[Yes] , and the next
box appears.
Select [Yes] to
activate it.
Factory default
Lamp control
Lamp control
This function allows you to change brightness of the screen.
Auto···· the controlled brightness according to the input
signal
Eco1···· the controlled brightness according to the ambient
light
Eco2···· 80% lower brightness than normal brightness and
reduces the lamp power consumption.
Normal···· normal brightness
NOTE:
●
You can also select a lamp mode with the LAMP CONTROL button on the remote
control. (p 20)
Press the Point Left / Right
button, to change the dialog
-
- -
For reducing power consumption as well as maintaining the lamp life,
the Power management function turns off the projection lamp when
the input signal is interrupted and no button is pressed for a certain
period.
When the input signal is interrupted and no button is pressed for 30
seconds or more, the timer display with "No signal" message appears
on the screen to start the countdown.
The following operation differs according to the selected mode.
Ready . . . . . . . .When the count-down time has elapsed, the lamp
will be turned off and the POWER indicator slowly
blinks green. When any signal is connected or
any button on the remote control or the front
panel is pressed, the projection lamp will be
turned on again.
Shut down . . . . . When the count-down time has elapsed, the lamp
will be turned off and the POWER indicator emits
orange light. When the lamp has been fully
cooled down, the power will be turned off.
Off . . . . . . . . . . . Power management function is off.
Power management
Time left before lamp
will be off
Power management
Press Point Left / Right button,
to change the dialog Ready -
Shutdown - Off.
Timer can be adjusted with Point
Left / Right button between 1 to
30 Min.
This arrow indicates that there are previous
items. Select this item and press the Point
Up button to go to the previous item.