54
Follow these steps to replace the lamp.
Lamp
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
Ɣ
Model No. of your projector : PLC-WXL46A
Ɣ
Replacement Lamp Type No. : POA-LMP106
POA-LMP106
(Service Parts No. 610 332 3855)
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Allow the projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of the
projector can become very hot.
CAUTION
Screw
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
Loosen the two screws that secure the lamp. Lift the
lamp out of the projector by using the built in handle.
1
3
Replace the lamp with a new one and secure it with the
two screws. Make sure that the lamp is set properly.
Put the lamp cover back and secure it with the screw.
4
Turn the projector over. Remove the screw that
secures the lamp cover, and then open the lamp cover.
2
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp replacement counter.
See “Lamp Replacement Counter” on the next page.
5
Handle
Screw
CAUTION
Screw
Lamp Cover
When the projection lamp of the projector reaches the end
of its life, the LAMP REPLACE indicator emits a yellow light.
If this indicator lights yellow, replace the lamp with a new
one promptly.
Top Control
Lamp Replacement
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
This indicator
turns yellow
when the
projection lamp
reaches the end
of its life.
Maintenance and Cleaning
3
Note:
The Lamp replacement icon will not appear
when the Display function is set to “Off” (p.41),
during “Freeze” (p.23), or “No show” (p.24).
Lamp replacement icon
Содержание PLC-WXL46A
