11
RESET
WIRED
R/C
OUT
IN
CONNECTING PLASMA MONITOR
TERMINALS OF PLASMA MONITOR
This Plasma Monitor has INPUT TERMINALS and OUTPUT TERMINALS on its side and back, for connecting
computers and video equipment. Refer to the figure on page 12 and connect properly.
SIDE
This jack outputs signal from RC IN jack.
To control two or more Monitors with one
Remote Contorl Unit, you need to
connect one end of a cable (not supplied)
to this jack and the other end to another
Monitor’s RC IN jack.
RC OUT JACK
If you control this Plasma
Monitor by computer, you must
connect a cable(not supplied)
from your computer to this
terminal.
SERIAL PORT IN TERMINAL
SERIAL PORT OUT
SERIAL PORT IN
COMPUTER IN
AUDIO (R/L)
D-SUB
RS-232C
RS-232C
BACK
Connect computer outputs to
these terminals. (Refer to P12.)
●
RGB (D-SUB)
●
AUDIO (R/L) (Stereo Mini Jack)
PC INPUT TERMINALS
This terminal outputs signal
from SERIAL PORT IN. More
than two monitors can be
controlled with one computer by
connecting SERIAL PORT IN of
another monitor to this terminal.
SERIAL PORT OUT TERMINAL
When using Remote Control Unit as
Wired Remote Control, connect it to this
jack with Remote Control Cable
(supplied). (Refer to page 14.)
RC IN JACK
The Plasma Monitor uses a
micro processor for control,
and occasionally, needs to be
reset. This can be done by
pressing the RESET button
with a pen, which will shut
down and restart the unit. Do
not use the RESET function
excessively.
RESET BUTTON
This terminal is not
available for computer
connection.
