Sanyo 26 series, Руководство по установке

Страница: 81 / 110

8 1
RC
(WL)
S lidi ng s witch 1
Wirele ss remote controller tran s mitter
Verify that s lidi ng s witch 1 i s i n the “K” po s itio n .
<For 3072R, 3672R>
S : Flap model (4-directio n , ceili ng sus pe n ded)
K: S wi ng -o n ly model (wall-mo un ted), s etti ngs completed
N: No-flap model (b u ilt-i n )
S K N
Verify that s lidi ng s witch 1 i s i n the “ S ” po s itio n .
<For 2672R>
S K N
S lidi ng s witch 2
S EN S OR b u tto n
RE S ET b u tto n
S et s lidi ng s witch 2 to the correct s etti ng for the s e model s .
A: Heat p u mp model
(H: Heat p u mp, n o a u to heati ng /cooli ng )
C: Cooli ng -o n ly model
A H C A H C
7-19. Te s t Run Procedure
<RC S - S H1UA>
7-20. Check Item s Before the Te s t Run
Wall-mounted model
(For new refri
g erant R410A)
Inverter unit ( S u p er E sp acio)
Con s tant- sp eed unit
Wall-mounted Ty p e
(K Ty p e)
Check the “Check Item s Before the Te s t R un .”
S et the i n door un it co n troller to “TE S T.”
Ret u r n the i n door un it co n troller to
“NORM.” (Item 7-21- 3 )
NO
I s operatio n
po ss ible?
Verify the combi n atio n (wiri ng ) of i n door a n d
o u tdoor un it s .
Check us i ng the s elf-dia gn o s tic s
f un ctio n table. (Refer to 11-7)
Correct a n y locatio ns that req u ire
correctio n .
YE S
Note: Check the i n door- s ide drai n a g e.
(Item 7-20)
(Item 7-21- 3 )
(1) T u r n ON the remote power s witch at lea s t 5 ho u r s before the te s t r un i n order to char g e the cra n k-ca s e heater.
(If the o u tdoor un it i s a n i n verter un it, t u r n ON the power 12 ho u r s i n adva n ce.)
(2) F u lly ope n the s ervice valve s o n the g a s -t u be a n d liq u id-t u be s ide s .
( 3 )
S et the s lidi ng s witche s o n the i ns ide of the wirele ss remote co n troller cover to the correct s etti ngs for that model.
After cha ng i ng the s etti ngs , pre ss the RE S ET b u tto n .
05-354-1 PAC-i_II 2/13/06 6:37 PM Page 81