Sanotechnik 10591131, Руководство пользователя и инструкция по установке

Страница: 19 / 72

Reset the device
It is possible to reset the heater by erasing all the settings made (programs, cali -
bration, maximum temperature, heating indicator). This function is useful in the event of
programming errors.
1. Press the and keys at the same time for more than 3 seconds to display ;
2. Press 3 times to display ;
3. Press , flashes alternately with ;
4. Press to display ;
5. Press to validate, all the indicator lights come on then the heater returns to Manual
mode at 19 °C;
AUTOMATIC DRAIN
In order to increase the life of the appliance and optimize its operation,
an automatic drain is integrated on the upper part of the frame of the
towel heater. It works in total autonomy and does not require any mani-
pulation by the user.
19
EN
CARE
Use a soft, dry cloth. For persistent stains, use a cloth dampened with soapy
water and wipe immediately with a dry cloth.
Specifications or contents of this manual may be changed without
prior notice due to upgrades or quality improvements of product
functions;
!
IN CASE OF MULFUNCTION
Check whether the problem is one of those mentioned in the “Troubleshooting” section.
If the problem persists, contact your supplier who will evaluate if the device can be
repaired or must be replaced. In both cases the entire device must be returned to the re-
tailer and it must never be tampered with, otherwise the warranty will not be valid. Make
sure you save your proof of purchase.
The control box does not turn on
The device is on standby mode. Press any key to activate the display. Check that the
device is electrically powered. Check that the switch is in position I.
The heating LED does not light
The heating LED lights only when the heating element is powered. Check that the stand
by LED was not turned off (Chapter Advanced Functions).
The room temperature is different from the one displayed on the device
It is necessary to wait at least 6 hours for the temperature to stabilize. It is possible to
adjust the set temperature to the temperature measured in the room (see “Calibration” in
TROUBLESHOOTING