23
8-2. REMOVING BELT
1. Loosen belt following “8
-1. LOOSENING
BELT”, p. 2
1-22.
2. Remove all the return rollers, if any. (→See “3
-
1. INSTALLING STANDS AND RETURN ROLLERS”,
p. 9.)
3. If machine has stands, only on one side, remove all the stand brackets(*1) and their attachment
bolts(*2)(M6, 4 bolts for each bracket). Machine will then have a space to pull out belt.
NOTE: If machine is equipped with belt removal stands(optional), only on one side, loosen upper lock
knob(*3) and lower lock knob(*4) of each stand by turning them counterclockwise with your
hand. To make a space between frame and stands, turn rotating stand brackets(*5)
downward. (→See figure, below)
4. Pull belt(*6) out of space between frame and stands sideways.
5. For belt installation, perform in reverse order.
NOTE:
1. Since conveyor becomes unstable when removing belt, be sure to support by plural workers etc. There
is considerable risk of being injured by toppling conveyor.
2. Be sure to stop conveyor and switch off power supply before loosening/removing belt.
3. Since drive unit of wide type is heavy, be sure to support frame on belt removal side when removing
belt. There is considerable risk of being injured by toppling conveyor.
4. After washing, completely dry belt before reinstallation.
5. When installing belt, confirm that arrow mark on belt undersurface correctly shows direction of belt
travel.
6. If belt is loose in operation after installation, take up belt slack. (→See p. 1
7.) If belt is deviating in
operation, adjust belt alignment. (→See p.
18-20.)
Arrow mark on belt undersurface
(Direction of belt travel)
Belt (*6)
Attachment bolt (*2)
Stand bracket (*1)
Remove/insert
belt this way
Stand
Direc
tion o
f belt
trave
l
●
Removing stand brackets
Arrow mark on belt undersurface
(Direction of belt travel)
Belt (*6)
Remove/insert
belt this way
Low
er lock knob (*4)
(Optional)
Upper lock knob (*3)
(Optional)
Rotating stand
bracket (*5)
Direc
tion o
f belt
trave
l
●
Conveyor with belt removal stands
(optional)
