SANKI MFC-S3B-F, Инструкция по эксплуатации

Страница: 29 / 36

27 / 32
2) Parameter list
Each time the Vol ▲ key is pressed, the parameter display switches in the descending order of the following
table. Each time the Vol ▼ key is pressed, the parameter display switches in the ascending order.
No. Function Description Setting range
Default value
Change
during
operation
Display
according to
the operation
mode
operation pattern
1 2
ｎ Ａ
0A
ON delay timer in2 Input ON delay timer
0.0-9.9 0.0 〇 〇 〇
0b
OFF delay timer in2 Input OFF delay timer 0.0-9.9 0.0 〇 〇 〇
0C
Soft start Output soft start timer 0.2-9.9 0.2 〇 〇 〇
0d
Soft stop
Output soft stop timer
0.2-9.9
--: Invalid
-- 〇 〇 〇
0E
Start delay timer Output start delay timer 0.0-9.9 0.0 〇 〇 〇
0F
Stop delay timer OUT4 Output stop delay
timer
0.0-9.9 0.0 〇 〇 〇
0n
Parts shortage in2 Input parts shortage
detection
0-99 30 〇 〇 〇
0L
Remote Unit
setting oF: The remote unit is invalid.
on: The remote unit is valid.
oF/on oF 〇 〇 －
0P
PI control gain Setting of the speed of output
response to vibration change
when the constant-amplitude
control is in process
1 (slow)
⇔ 27 (fast)
1-27 10 〇 〇 〇
06
in1 setting
in1 Input logic
hi:
Operation
with the contact
“Close”
Lo:
Operation
with the contact
“Open”
Lo 〇 〇 －
07
in2 setting
in2 Input logic
hi 〇 〇 －
08
OUT2 setting Setting of OUT2 Output
function
AL/Er AL 〇 〇 －
09
FBU amplification
setting Set the amplification rate of the
feedback sensor value.
0 (no amplification)
⇔ 3 (large
amplification)
0-3 3 × 〇 －
00
Voltage limit
setting Limit the maximum value of
the output voltage. 1-99
--: Invalid
-- × 〇 －
Display pattern No.
Backup display pattern No. PAt1 PAt2 〇 －
% display
Output voltage backup display 0.0 0.0 〇 －
Hz display Frequency backup display
180.0 180.0 〇 －
Version information Program version
V100 〇 －
io mode No. display
io01: With overflow stop
io02: Without overflow stop
io01/io02 io01 〇 －
0u
Amplitude control
setting 0: Constant voltage
1: Constant-amplitude
0-1 0 〇 〇 －
Change during operation: 〇 … Enabled, ×… Disabled ， … Not applicable
Display according to mode: 〇 … Enabled, －… Disabled