KBox C-103-CFL-x - User Guide, Rev. 1.0
// 40
5.2.
(X205) - Serial Port RS232/RS422
This port can be only factory installed and configured.
When you order the KBox C-103-CFL with this extended interface via RS232/422 adapter
module, you have to specify in your ordering:
the needed configuration of this port as RS232 or RS422 and
for RS422 configuration: if the onboard termination resistor (120
Ω
) should be enabled or
disabled.
Your KBox C-103-CFL can be extended, via an adapter module, with an additional serial interface RS232/RS422. This
serial port (Figure 26, pos. 1) is available as 9-pin D-SUB connector (male), marked as “SERIAL” on the front side of the
system. It must be factory configured as RS232 or RS422 corresponding your ordered port configuration. The serial
port will be configured via an on-board DIP switch (SW1) for RS232 or RS422 serial communication. This port is
galvanically isolated (500V).
Your system order with RS422 port must also contain the specification about the termination resistor (120
Ω
). If your
application requires the termination resistor, it must be enabled at factory only. For pin assignment refer to
subsection 13.2.4.
5.3.
LTE M.2 module
The KBox C-103-CFL can optionally be equipped with cellular technology LTE (4G) to meet GCF or PTCRB. Please
request this option if required.
5.4.
(X204) - CAN Port
Your KBox C-103-CFL can be extended via an adapter module with one CAN port (SJA1000 implementation), that
allows layer 2 CAN communication. The optional CAN port (Figure 26, pos. 2) is implemented as a sub-D 9 pin
connector (male). This port is galvanically isolated (500V).
For pin assignment refer to the section 13.2.5.
If a termination resistor (120
Ω
) is required, you have to make a connection (bridge) between
pin 1 and 2, respectively pin 7 and pin 8, in order to enable the onboard termination resistor
(120
Ω
).
5.5.
(X203) - 3
rd
DisplayPort
Your KBox C-103-CFL can optionally be extended with a third DisplayPort (Figure 26, pos. 4).
The DP 3 port is a DisplayPort compliant interface realized using a standard DisplayPort connector. An external
(digital) display can be connected to the DisplayPort connector (Figure 26, pos. 4).
For pin assignment refer to subsection 13.1.5.
Содержание kontron KBox C-103-CFL Series
Страница 2: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 2 This page has been intentionally left blank...
Страница 28: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 28 Figure 12 Block Diagram KBox C 103 CFL x...
Страница 124: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 124...
