KBox C-103-CFL-x - User Guide, Rev. 1.0
// 50
6.2.
Opening and Closing the KBox C-103-CFL
The pictures in this section correspond to a KBox C-103-CFL-2 system.
The “opening/closing” procedure description can be applied to all system variants, under
consideration of the different mechanical specifications of the KBox C-103-CFL; refer to the
section 12.1 “Mechanical Specifications of the KBox C-103-CFL”.
For opening/closing the KBox C-103-CFL, please perform the following steps:
The system must be powered off and disconnected from the main power supply, before you
attempt to open the KBox C-103-CFL. Ensure that you have a clean, flat and ESD-safe surface
to work on. Also disconnect all peripheral devices from the KBox C-103-CFL. Please observe
the instructions contained in the chapter 8/ “Installation Instructions”.
1.
Close all applications. Shut down the system properly and disconnect the connection to the power source.
Disconnect all peripherals.
2.
The KBox C-103-CFL should lay on a flat, clean surface with the top side facing upwards.
3.
Loosen the knurled screws, which secure the top cover on the front of the system (see Figure 11 and Figure 35).
4.
Pull the cover out a little bit, as shown in Figure 35, to release the cover centering and fixing brackets.
Figure 35: Removing the centering and fixing bracket of the top cover (detail of the KBox C-103-CFL-2)
5.
Lift the top cover up (on the front edge) and remove it (Figure 36). Now you have access to the internal sockets
(PCI/PCIe/M.2) or to the corresponding cards/devices, in order to install or remove internal hardware
components.
Figure 36: Removing the cover (detail of the KBox C-103-CFL-2)
Содержание Kontron KBox C-103-0
Страница 2: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 2 This page has been intentionally left blank...
Страница 28: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 28 Figure 12 Block Diagram KBox C 103 CFL x...
Страница 124: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 124...
