Sandstrom S5GONGB13, Инструкция по эксплуатации

Страница: 9 / 24

9
3. Hold an ignition source (e.g. candle lighter) close to the side of the burner and press the burner
control in fully to release and light the gas.
The control must still be held down for approximately 5 – 10 seconds after the burner has lit.
Releasing the controls too soon will extinguish the flame.
4. Adjust the controls as required.
Flame Failure Safety Feature
The flame supervision device (FSD) probe cuts off the gas supply to the burner within one minute if the
flame is extinguished.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at
least one minute (to allow the gas to disperse).
When lighting the burner, hold down the control for approximately 5 – 10 seconds after the burner has
lit. Releasing the control too soon will extinguish the flame.
If the Burner Does Not Light
If the burner does not light, check that:
• The hob is connected to the electrical supply and the supply is switched on.
• The gas is turned on.
• You have held down the control for at least 5 – 10 seconds after the flame has been lit.
• The ignitors are sparking. If the ignitors are not sparking,
they may be dirty or wet. Clean them gently with a small nylon
brush such as a toothbrush as shown opposite and allow to
dry fully. Ensure the electrical supply has been
disconnected before cleaning.
To avoid damage to the ignition circuit
NEVER light the hob when the burners
are not in place.
If the Flame is Irregular
If the flame is yellow or irregular, check that the burner parts,
including the burner cap (allow this to cool before touching) are:
• Clean and dry.
• Positioned correctly. See ‘Replacing the Burners’.
• Also see ‘Hints and Tips’.
Ignitor
Flame failure
probe
Burner Cap
Electrode
Burner Ring