Manual Charging Tool Assembly
Ç
WARNING
DO NOT use the charging tool as a hotstick .
Serious injury or death can result. Only
use the charging tool for closing and charging
Trans-Rupter II pole-units .
The manual charging tool is shipped fully
assembled but can be disassembled for storage.
Figure 71. Remove the linchpin between the tool handle and the insulated
shaft.
Linchpin
Figure 72. Pull the tool handle and the insulating shaft apart.
Linchpin
Tool handle
Insulating shaft
NOTICE
To prevent excessive wear or corrosion, store
the Trans-Rupter II charging tool in a dry, pro-
tected area when not in use .
Disassembling the Charging Tool
Step 66
Remove the linchpin that attaches the insulat-
ing shaft to the tool handle, then pull these
components apart. Push the linchpin through
the holes of the insulating shaft for storage. See
Figures 71 and 72.
S&C Instruction Sheet 731-502
37
