INSTRUCTION SHEET
716-600
Page 23 of 24
February 11, 2002
S&C ELECTRIC COMPANY
Step 47
Press—and hold for 5 seconds—the sytem set-up button.
The A-phase set-up prompt will be displayed. See Figure
23.
Step 48
To initialize A-Phase, press and release the set-up button
again. Then position and hold the magnet tool flush
against the side of the transmitter as shown in Figure 24.
Make sure that the two poles of the magnet are aligned
vertically. When the receiver starts counting signals from
the transmitter, remove the magnet tool. See Figure 25.
When the magnet tool is applied correctly, the receiver
will display the serial number of the interrupter/transmit-
ter—after 10 rapid signals are detected, the display will
prompt you to move on to B-Phase, and then C-phase.
Repeat Step 48 for B-phase and then again for C-phase.
See Figures 25 and 26.
NOTICE
During normal operation, the transmitter sends a sig-
nal to the receiver antenna once every hour. When the
magnet tool is applied to transmitter, the transmitter is
prompted to send a signal to the receiver once every
second. The transmitter will continue to send this sig-
nal for up to 10 seconds after the magnet tool is
removed.
The system will assign phase designations in the
order in which the phases are initialized. The first
phase initialized will be assigned the letter “A,” the
second “B,” and the third “C.” Make sure that the
phases are initialized in the order appropriate for the
installation.
Store the magnet tool inside the switch operator
door for future use.
INTERRUPTERS WITH THE REMOTE GAS-DENSITY MONITOR OPTION — Continued
S&C RGDM “A” Phase
SS-0608-001
: 9
Got 10 Packets From
SS-0608-001
Which Is Phase “A”
S&C RGDM A-Phase Set
Up. Use Magnet To Start
A-Phase Remote.
Press Button To Go
Figure 23. Receiver LCD prompt for magnet tool.
Figure 25. Receiver LCD counting transmissions from
transmitter box.
Figure 26. Receiver LCD after receiving 10 signals from
transmitter.
Figure 24. Position of magnet tool. Place magnet tool flush
against the side of the transmitter with the serial number
stamping.
Magnet tool
