Samyung SRG-315DN, Руководство пользователя

Страница: 36 / 57

35
Chapter 9. How to use print
9.1. DPU-414 Printer
(1) Caution for use
a) The printing paper used for the DPU-414 is a
special kind of paper which turns black by the
thermo chemistry reaction.
Take as following precaution when using the paper.
Store away from Hit, Humidity, light.
Dry hands before handling with the paper
Don't rub the paper with any kind of hard or
coarse materials.
Don't use organic adhesive on the paper. (Instead
of that, water-based starch adhesives or compound
adhesive.)
Don't use adhesive tape on the paper. (However,
using both sides tape is possible.)
Don't allow the paper to remain in contact with
polyvinyl chloride film for a long
time.
Don't leave the paper in contact with freshly
coped giazo type or wet process
paper.
Don't allow the paper to come into contact with
organic solvents.
b) Caution for operation
Check there is a paper in it before use.
Don't turn off while operation and turn off after
PRINT HEAD is at HOME POSITION.
Printer test function is built-in.
(2) Operation Panels
a) POWER Switch
Switch on the turn this unit on. Printer head do
going and returning once, the paper is fed by one
column.
On condition that main unit of SRG-3150DN is
power on.
b) FEED Switch
Press FEED switch when feed the paper out by
force.
On pressing this switch once, it will be feed once
and on pressing this switch continuously, it will be
kept feeding.
c) CUTTER
Use for cutting the printer paper.
d) Exit of paper - It is the part where the paper is
ejected through it.
e) PAPER COVER
Store up the paper inside it.
(3) Usual operation.
Check the main unit of SRG-3150DN is turned on.
If power on, it is able to print TX/RX DSC MESSAGE
and DATA from SRG-3150DN automatically.
(4) How to store the printer paper roll
a) Cut the printer paper horizontally.
If there is the wrinkle on the paper, it may cause
the paper jam.
< PRINTER PAPER HANDLING >
b) Switch off the printer
c) Open the PAPER COVER and pull out the CENTER
SHAFT.
d) Insert the CENTER SHAFT in the center of the
PAPER ROLL and put the end of the paper into the
way-in of the paper.
e) Switch of the PRINTER and press the FEED KEY
until the paper is hauled.
f) Store up the center shaft and the paper gets out
of the way-out.
g) Press FEED KEY until the end of paper gets out
of the way-out.
h) Close the PAPER COVER and put it down to shut.
9.2. OKI Printer
(1) Common Operation
a) Check out the power of SRG-3150DN connected
with a Printer ON.
b) Pull the switch of the POWER up to turn on the
power.
c) The DATA and DSC MESSAGE transferred from
SRG-3150's transmitting and receiving process is
automatically activated.
(2) PAPER LOADING
a) Place the printer on a slotted printer stand,
carefully aligning the slot in the stand with the
opening in the base of the printer.
b) Place the box of paper under the printer stand.
c) Remove the access cover and lift the column
indicator bar.
d) Open the paper release lever.
e) Insert the first sheet of paper through the
opening in the bottom of the printer.
f) Slide the paper up until it appears in front of
the platen.
g) Lower the column indicator bar.
h) Close the paper release lever.
i) Use the platen knob to advance the paper to
the first printing line.
j) Replace the access cover.