- 18 -
7. Function Buttons
1) The Function Buttons have 75±16.7ms of the effective time of pressing.
2) If the press of a Function Button is sensed, a function button sound is heard.
3) If two or more buttons are pressed, the button pressed first will be selected.
(Except for special buttons (Power Button))
4) Cases where Function Buttons are not selectable:
①
. No buttons can be selected after pressing the Start command, except the Power Button,
the Start/Pause Button, and the Child Lock Button.
②
. The selection of the Wash Temperature is not accepted if a cold course was already
selected.
③
. In the case where an Error is generated, all buttons except the Power and Start buttons
cannot be selected.
④
. If the Child Lock function is set, only the Power and Child Lock Release buttons can be
selected.
⑤
. Completed cycles cannot be selected again.
8. Detailed Information for Each Cycle
1) Common Information for Every Cycle
①
. If each cycle is selected, it progresses in the following order:
(Prewash)
→
Wash
→
Spin
→
Rinse
→
Spin
→
Rinse
→
Spin
→
Rinse
→
Final Spin
→
End
②
. If the Start/Pause button is pressed during the operation of a cycle, it stops that cycle. One
more press of the button will re-start that cycle. (In this manner: Stop
→
Start
→
Stop
→ㆍㆍ
)
③
. During the pause the remaining time does not decrease and every steering part (Motor, Valve,
Heater, ect.) stays in the OFF condition.
④
. The LED display of each course and the cycle stays On at the time of selection, while it
refreshes every 0.7 second while operating. The LED of a finished cycle turns OFF.
⑤
. A buzzer will sound every time a cycle is set up.
⑥
. It is possible to change the course and cycle with the function buttons during the operation of
a course. (Except for the Lingerie and Wool Courses)
⑦
. If users swich on the Power, a melody plays once.
⑧
. It is not possible to select any button, except the Power Button, while the melody sounds.
⑨
. When the Power is switched On, the steering parts (Motor, Valve, Heater, etc.) are in an Off
condition and the Cotton Course is selected as default.
2) Wash Cycle
The Wash Cycle performs the following operations: Water Supply/ Water Stirring/ Wetting/
Heating/ Washing/ Cooling/Drain.
( Wetting/Heating/Cooling cycles are performed only when the temperature is set to over 40
℃
.)
