- 15 -
- Silver Anti-bacteria: the silver nano kit starts operation in water supply for the last
rinse cycle.
●
When the silver nano key is selected, the last rinse time becomes longer than the others for
effective anti-bacteria feature.
●
When the silver nano key is selected, the silver nano LED turns on and when the wash or rinse
cycles are done, the LED turns off. And the LED blinks when the silver nano kit starts
operation or during the silver sterilization or anti-bacteria rinse cycles.
3) Wash Button
●
The user can select one in this order: Wash
→
Prewash
→
Wash Only
→
P Wash Only.
4) Rinse Button
●
The number of rinse times for each course can be selected in successive order
Number of Rinse Times
→
+3 times
→
+4 times
→
+5 times
→
6 times
→
1 time
ㆍㆍㆍ
.
The WASH and SPIN procedures will be deleted at this time. However, they are not
deleted if the Rinse Button is handled after the selection of Wash-Only or Spin-Only.
●
When the Rinse Button was selected, the number of rinse times can be selected from betwen
1 and 6 times for each course.
5) Spin Button
●
A rotation speed for the dehydration cycle can be selected in the following order:
800
→
1000
→
1200
→
600.
●
The WASH and RINSE procedures will be deleted at this time. However, they are not
deleted if the SPIN Button is selected after the selection of Wash-Only or SPIN-Only.
6) Drying Selector Button
●
The drying process is performed according to the steps below when the Drying button
is pressed.
- Standard → Sterilization → Easy Iron → Low temperature → Time setting (30min → 60min
→ 90min → 120min → 150min) → Cancel
●
The button does not perform a standalone cycle, but an additional course added to the
other cycles
●
When selecting Drying, the Drying icon is turned on and pressing it again turns it off.
●
This function cannot be selected after entering the drying cycle and is only changeable
when Paused. However, it cannot be selected in Pause mode when Drying for normal
courses has been selected.
●
It can only be selected in the Cotton, 95℃, 65℃, Coloureds, Quick or Dedicated Drying
courses
7) Delay Start Button
●
This button functions to reserve the end time of the function currently set. Set the
Delay Start time and press the START button to operate this function.
●
The Delay Start time can be selected in hourly units and in a 24 hour range.
●
It is impossible to change the Delay Start time and the course after the operation starts.
●
After selecting this function, the Delay Start LED stays ON for the whole duration time.
●
The Delay Start time decreases in hourly units.
8) Add Laundry Button
●
You can add laundry when a cycle or operation is in process or the door is closed under
conditions other than the door being unlocked and the temp. sensor of the fan housing
