Samsung WEC8500, Руководство по эксплуатации

Страница: 469 / 689

CHAPTER 10. System Management
© SAMSUNG Electronics Co., Ltd. page 469 of 689
CHAPTER 10. System Management
In this chapter, the various functions used by an operator to manage the system and
troubleshooting method are described. In addition, the configurations required for system
operation such as system configuration management, resource management, alarm
management, and package management, etc. and checking methods are described.
10.1 SNMP Configuration
10.1.1 SNMP Community
To use an external management server or to manage the system through a web server after
initial system installation, you must configure the SNMP community using CLI.
When creating the SNMP community, you can restrict configuration privilege by allocating
the access right such as read-only or read-write and can also restrict an IP to connect.
You can configure maximum 10 SNMP communities.
Configuration using CLI
To add a SNMP community, execute the command as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Use the ‘snmp community’ command to add a SNMP community.

snmp community [COMMUNITY_NAME] [ACCESS] [IP_VERSION]
[IP_ADDRESS] [NET MAST]
Parameter Description
COMMUNITY_NAME Name of a community to add
ACCESS Access privilege (rw/ro)
- rw: read-write privilege
- ro: read-only privilege
IP_VERSION IP address version type (v4/v6)
IP_ADDRESS, NETMAST IP address area that can be connected
3) To check the created SNMP community, use the ‘show snmp community’ command.