Samsung WEC8500, Руководство по эксплуатации

Страница: 168 / 689

CHAPTER 4. AP Connection Management
© SAMSUNG Electronics Co., Ltd. page 168 of 689
Parameter Description
the NAT environment, you must enter an official IP configured in the NAT
instead of the private IP of APC.
PUBLIC_PORT PUBLIC CAPWAP PORT number of the APC to add
This port number is required by an AP to connect to the APC. If the APC is
under the NAT environment, you must enter the port number configured in the
NAT instead of the actual CAPWAP port number of APC.
FALLBACK
START-END
TIME
Enter the time zone where an AP connected to the backup (secondary or
tertiary) APC can do fallback.
The input format is as follows:
Format: hh:mm-hh:mm
Example: 2:00-5:00

Fallback is available between 2pm and 5pm.
INTERVAL Configures the interval that an AP connected to the backup (secondary or
tertiary) APC attempts fallback (second).
If a specific time is not entered, the default is 120 seconds.
The minimum is 60 seconds and the maximum is 1800 seconds.
3) In the menu bar of <WEC Main window> , select <Configuration> and then select
the <Access Points> menu in the sub-menus. Click the name of AP Profile to which
the redundancy function will be applied. After configuring the DISCOVERY TYPE of
AP to ‘APC Referal’, select the PRIMARY CONTROLLER NAME, SECONDARY
CONTROLLER NAME, and TERTIARY CONTROLLER NAME. For the WEC8500
model, the TERTIARY CONTROLLER NAME is not shown in the menu.
Figure 86. AP retrieving window