Disassembly and Reassembly
3-1
Samsung Electronics
3. Disassembly and Reassembly
3-1 General Precautions on Disassembly
When you disassemble and reassemble components,
you must use extreme caution. The close proximity of
cables to moving parts makes proper routing a must.
If components are removed, any cables disturbed by the
procedure must be restored as close as possible to their
original positions. Before removing any component from
the machine, note the cable routing that will be affected.
Whenever servicing the machine, you must perform
as follows:
1. Check to verify that documents are not stored in
memory.
2. Be sure to remove the toner cartridge before you dis-
assemble parts.
3. Unplug the power cord.
4. Use a flat and clean surface.
5. Replace only with authorized components.
6. Do not force plastic-material components.
7. Make sure all components are in their proper position.
>> Releasing Plastic Latches
Many of the parts are held in place with plastic latches.
The latches break easily; release them carefully.
To remove such parts, press the hook end of the latch
away from the part to which it is latched.
3-2 White Roller
1. Open the OPE Cover.
2. Push the Bushing on the end of the Roller slightly
inward, then rotate it until it reaches the slot.
Then lift, the Roller out.
Control Panel
Bushing
White Roller
White Roller
Note : Check the Roller for any dirt. If dirty, wipe it off with soft
cloth dampened with water. If the Roller is heavily worn,
replace it with a new one.
