Samsung SCX-82x0 series, Руководство по обслуживанию

Страница: 314 / 399

7. Troubles
●
C d
●
E
●
Code :
M1-1610
●
Error message :
Paper jam in MP tray
●
Symptom / Cause :
Paper transport jam (paper Input section)
- The paper has not reached the regi sensor within nor The paper has not reached the regi sensor within nor
●
Troubleshooting method :
1. Remove the jammed paper from the MP tray.
2 Open the side door Remove the jammed paper 2. Open the side door. Remove the jammed paper.
Close the Side door. After warm up, if same jam occ
3. Install the MP Pick up (forward, retard )roller correct
4. If the MP pick up roller( JC90-00989A ) is worn out or
5. Check if papers in the MP tray are curled, replace th
6. Open the side door and remove the lower cover from
the MP tray unit and the connector of the joint PBA are
7. If the problem persists, remove the MP unit( JC90-00
a If the spring at the bottom of the MP unit breaks aw a. If the spring at the bottom of the MP unit breaks aw
If the assembly mold part with spring is broken, re
b. If the spring of the guide to fix the pick up roller in M
c. If the error message displays despite paper empty
interrupt. Reassemble the empty actuator or replac
d. If the driving gear breaks away or is broken, reasse
In case that the actuator is broken, check the following
1. Does the pick up (forward) roller rotate?
a. Check if the MP clutch connector is connected pr
b. Enter the diagnostic mode. Execute “MP clutch te
c. Check if the motor connector of the MP drive unit
d If MP solenoid( JC33-00029B ) on but pick up rolle d. If MP solenoid( JC33 00029B ) on but pick up rolle
part defect. And reassemble it.
e. Enter the diagnostic mode. Execute “MP drive mo
2. Replace the main board(JC92-02587A(for 8240) / JC
Service Manual
7-M
shooting
y.
rmal time after MP pick up. rmal time after MP pick up.
curs, check the following.
tly.
r contaminated, replace it.
he paper or stretch to remove curling.
m the rear of the side unit. Check if the connector of
e connected properly. Reconnect the connector.
0921A ) from the side unit and check the following.
way or is broken replace the spring way or is broken, replace the spring.
eplace it.
MP unit breaks away, reassemble or replace it.
in the cassette, check the empty actuator and photo
ce the photo interrupter.
emble or replace it.
g :
operly. Reconnect it.
est” . If it is defective, replace it.
is connected properly. Reconnect it.
er moves down check for each link part missing er moves down, check for each link, part missing,
otor test” . If it is defective, replace it.
C92-02587B(for 8230))
SAMSUNG ELECTRONICS
M-3