Samsung OfficeServ500, Руководство по установке

Страница: 32 / 132

4-3
INSTALLING THE MCP2 CARD
CAUTION: Do not insert the card with system power on. Switch the power OFF.
1. Install the SmartMedia card into its position on the MCP2 card. ( Figure 4-1 .) Below the rows of LEDs
on the front panel is a small hinged flap marked “Smart Media.” Pull open this flap to access the slot for
the SmartMedia card. Carefully insert the SmartMedia card into the slot, ensuring that the connectors
are facing towards the metal carrying handle on the MCP2 card,
but taking care not to touch the
handle with the connectors . Push the card in until it clicks into place. Close the hinged flap.
2. Install the required daughterboard(s) on the MCP2 card (refer to relevant daughterboard(s), below).
3. Set the DIP switches to the desired positions (see table above).
4. Insert the card into the slot labelled MCP/LCP (
Figure 4-2 ). Push firmly at the top and bottom of the
card to ensure that it is fully inserted into the backplane connector. To prevent accidental damage to
the card, the MCP/LCP connector on the backplane is positioned to mate only with the MCP2 (or
LCP2) card. Other interface cards will not mate with this connector and the MCP2 card will not mate
with any other connector.
LED INDICATIONS
The 12 LEDs show the operational status of the MCP2 card, SmartMedia card and card slots 1–
9. The LED indications are described in
Appendix A .
Switch Control Processor Card (SCP2)
The SCP2 card ( Figure 4-3 ) is used when an ‘L’ system is expanded to more than one cabinet.
In a multiple cabinet system the card becomes the processor for the KSU and communicates via
a high-speed data link to the MCP2 card. The card installs in slot 9 of the KSU. It can have up to
three daughterboards installed, as shown in the table below.
SWITCH CONTROL PROCESSOR (SCP2) DAUGHTERBOARDS
Position Type of Daughterboard Allowed
LOC1 MFM, SCM*, RCM
LOC2 MFM, RCM and MISC
LOC3 MFM, RCM
* The SCM must be installed in this location in ‘L’ systems.
NOTE: Only one of any given type of daughterboard may be installed on any one SCP2
card (e.g. only one MFM can be installed on one card).