44 Users Manual
To swap a device with the power on proceed as follows:
1.
Start the
Softex Bay Manager Utility
.
You do not have to turn the computer over or tip it on its side to change
devices. Simply tilt the computer up about 10 cm at the back and locate the
Flex-Bay latch. See Figure below for the location of the Flex-Bay latch. The
computer in the figure is turned over for clarity.
2.
Click
Remove / Swap
. A Device Change popup window stating, “Please wait until
the system processes the device change” appears then another popup window
appears and says, “Please remove or swap your bay device(s) now and press OK.”
3.
Tilt the computer up and locate the flex-bay latch.
4.
Slide and hold the latch toward the rear of the computer.
5.
Slide the device out.
6.
Slide the new device in
7.
Click
OK
. The message “Please wait until the system processes the device
change” appears again.
8.
Click
OK
to close the
Softex Bay Manager Utility
.
If you swap devices while the power is on without using the Softex Bay
Manager Utility, the device and the system may be damaged.
Flex-Bay Latch
