36
4. Troubleshooting
4-1 Failure Display Codes
Safety error
Failure code
CAUSE
SOLUTION
E-08
Oven heating error
1. Disconnect power. Open the back cover.
Disconnect sensor harness from control.
Measure
VHQVRUUHVLVWDQFHȍDW
WKHURRPWHPSHUDWXUHĺ,IWKHUHDUHDQ\
problems, replace oven sensor.
2. Check the broil, bake and convection heater.
Check the resistance of the each heater.
3. Check whether DLB of Main PCB, Broil, Bake
and Convection heater relay are being worked
normally.
4. Check whether there is any disconnection of
harness which is linked with main PCB on sub
PCB.
5. Check the resistance of oven sensor
FRQQHFWRURQPDLQ3&%1RUPDOȍ
E-0A
Oven heating over
- SE -
Shorted key
1. Check whether cable of keypad has been
inserted into connector of Sub PCB.
2. Check whether between Sub PCB and
connector or keypad and cable have a short
circuit.
3. If there is not a problem occurred with
connector on Sub PCB and cable of keypad,
replace the Sub PCB.
E-0E
Door locking error
1. Disconnect power. Open the back cover.
Check wether harness has been connected
with door lock switch and motor.
2.
&RQ¿UPZKHWKHUUHVLVWDQFHYDOXHRIGRRUORFN
motor is to be normal one or not.
3. With operating door lockout, measure a
voltage of connector on harness which is
linked with door lock motor.
(Normal Voltage : AC 120V)
4. Check whether door locking switch is being
worked normally.
E-27
Oven sensor opened
RYHUȍ
1.
After 20 seconds from starting to work of
oven, buzzer is beeping 10 times long and
WKHQ¿QDOO\LWGLVSOD\V³(´RU³(´DV
Error message.
2. If a series of function for error is not performed
at all, please make sure through the method
of 4-1 on 35 page.
E-28
Oven sensor shorted.
8QGHUȍ
