16
Use of wired remote controller installation / service mode
Use of installation/service mode
1 2 3 4
Main menu
Sub-menu
SEG Used
1. If you want to use the installation/service mode for your wired remote controller, press the
Set
and
ESC
buttons at
the same time for more than 3 seconds.
f
You will enter the installation/service settings, and the 'main menu' will be displayed.
2. Refer to the list of installation / service setting mode for your wired remote controller on the next page, and select
the desired menu.
f
Using the
[∧]
/
[∨]
buttons, select a main menu number and press the
[＞]
button to enter the sub-menu setting
screen.
f
Using the
[∧]
/
[∨]
buttons, select a sub-menu number and press the
[＞]
button to enter data setting screen.
f
When you enter the setting stage, the current setting value will be displayed.
f
Refer to the chart for data settings.
f
Using the
[∧]
/
[∨]
buttons, change the setting value. Press the
[＞]
button to move to the next setting value.
f
Press the
Set
button to save the setting value and exit to the sub-menu setting screen.
f
Press the
ESC
button to exit to normal mode.
•
When setting the data, you can move SEG range with
[＜]
/
[＞]
buttons.
•
While configuring the setting, press the
ESC
button to exit to the sub-menu setting screen without saving your
changes.
•
When you don't enter any buttons for more than 3 minutes, you will be back to normal mode.
NOTE
DVM Hydro Unit_MWR-WW00_IM_EN_03647A(1).indd 16
2013-01-09 오후 2:48:43
