English-39
Power Saver
This set has a built-in power management system called PowerSaver. This system saves energy by
switching your set into a low-power mode when it has not been used for a certain period of time.
The available modes are “On”, “Standby”, “Sleep”, and “Deep Sleep”. PowerSaver operates with a
VESA DPMS compliant video card installed in your computer. You use a software utility installed on
your computer to set up this feature.
State
Normal Operation
Power-Saving Function mode
(EPA/NUTEK)
Horizontal Sync
Active
Inactive
Vertical Sync
Active
Inactive
Power Indicator
Green
Green, Blinking (1 sec interval)
Power Consumption
LS15E33C : 48W (Max.)
Less than 3W
LS17E34C : 58W (Max.)
➣
This set automatically returns to normal operation when horizontal and vertical sync return.
This occurs when you move the computer’s mouse or press a key on the keyboard.
Troubleshooting: Before Contacting Service Personnel
On PC mode, image is not stable and
may appear to vibrate.
On PC mode, image is not centered
on the screen.
◆
Check that the display resolution and frequency from your
computer or video board is an available mode for your set.
On your computer check: Control Panel, Display, Settings.
◆
If the setting is not correct, use your computer utility programme
to change the display settings.
➣
Your set supports multiscan display functions within the
following frequency domain:
Horizontal frequency -
15” : 30 ~ 69 kHz
17” : 30 ~ 81 kHz
Vertical frequency -
56 ~ 75 Hz
Maximum refresh rate -
15” : 1024 x 768 @ 75Hz
17” : 1280 x 1024 @ 75Hz
◆
Adjust the horizontal and vertical position.
BN68-00438G-01Eng-AS15CO 6/17/03 1:49 PM Page 39
