12_
installing your dishwasher
DISHWASHER INSTALLATION STEPS
1.
Install the furniture door to the outer door of the dishwasher using the brackets provided.
(Refer to the template of page 10 for positioning of the brackets. Attach a condensation strip as the
picture bellow.)
2.
Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten the
left and right door springs.
Failure to do this could cause damage to your dishwasher (Illustration 2).
3.
Connect the inlet hose to water inlet valve & to the cold or hot water supply.
CAUTION
: Make sure that the Aqua-stop is connected to cold or hot water supply.
Make sure that both ends of inlet hose are not water leakage.
4.
Connect the drain hose. Refer to “Connection of drain hoses”.
5.
Connect the power cord.
6.
Place the dishwasher into position.
CAUTION
: Be careful to avoid scratching the fl oor.
7.
Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning the
screws on the left and right hand side of the cabinet (Illustration 7A). To adjust the front feet, use a
wrench and turn the front feet until the dishwasher is level (Illustration 7B).
8.
The dishwasher must be secured in place.
There are two ways to do this:
A. Normal work surface : secure to the work surface by using two woodscrews ensuring the
dishwasher weight is not deformed by the surface (Illustration 8A).
B. Marble or granite work top : secure the bracket to the side panel of the dishwasher and secure the
dishwasher to the furniture housing. Put the rubber cap over the screw (Illustration 8B).
installing your dishwasher
RUBBER COVER
RUBBER COVER
SCREW
SCREW
1
1
8B
8A
7B
6
6
2
2
Furniture
Furniture
door
door
7
7A
DD81-01306A-01_EN.indd Sec4:12
DD81-01306A-01_EN.indd Sec4:12
2012-09-27 10:53:02
2012-09-27 10:53:02