using the detergent and water softener
_17
RINSE AID DISPENSER
1.
To open the dispenser, turn the cap to the “open” (left)
arrow and lift it out.
2.
Pour the rinse aid into the dispenser, being careful not to
overfi ll.
3.
Replace the cap by inserting it aligned with “open” arrow
and turning it to the closed (right) arrow.
The rinse aid is released during the fi nal rinse to prevent water from forming droplets on your
dishes that can leave spots and streaks. It also improves drying by allowing water to sheet off
the dishes.
Your dishwashers are designed to use liquid rinse aids. The rinse aid dispenser is located inside
the door next to the detergent dispenser. To fi ll the dispenser, open the cap and pour the rinse
aid into the dispenser until the level indicator turns completely black. The volume of the rinse aid
container is about 130 ml.
Be careful not to overfi ll the dispenser, because this could cause over sudsing. Wipe away any
spills with a damp cloth. Don’t forget to replace the cap before you close dishwasher door.
ATTENTION
: Clean up any rinse aid split during fi lling with an absorbent cloth to avoid
excess foaming during the next wash.
Adjusting rinse aid dispenser
The rinse aid dispenser has four settings. Always start with the
dispenser set on “3”. If spots and poor drying are problems, increase
the amount of rinse aid dispensed by removing the dispenser lid and
rotating the dial to “4”. We suggest you to set on “3” (Factory value is
“3”).
Increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes or a
bluish fi lm on glassware or knife blades.
03 using the detergent and water softener
DD81-01306A-01_EN.indd Sec5:17
DD81-01306A-01_EN.indd Sec5:17
2012-09-27 10:53:03
2012-09-27 10:53:03