APPENDIX
Troubleshooting
Symptom
Checklist
The Jet Bot is not working at all.
• Check if the power switch is on.
• Check if the Status Indicator is on.
• Check if the Jet Bot's battery is depleted.
– When the Jet Bot’s Status Indicator turns red and
stays red, place the Jet Bot manually on the Clean
Station to charge it.
• When you manually charge the Jet Bot due to complete
discharge of its battery, the buttons on the Jet Bot do
not work. When charging is partially complete (about
10-20 minutes later), the Status Indicator is on and the
buttons work again.
The Jet Bot has stopped during
cleaning.
• When the Jet Bot’s Status Indicator turns red and stays
red, place the Jet Bot manually on the Clean Station to
charge it.
• When the Jet Bot is immobilized by an obstacle such as
a cord, obstacles, threshold, a raised spot, etc., pick it up
and move it away from the obstacle.
– If any fabric or string is caught in a Driving Wheel,
turn off the power switch and remove the fabric or
string before using it again.
• Check whether the No-go Zones are set.
Suction power is weak.
• When there's too much dust in the Dustbin, suction
power may get weakened. Turn off the power switch
and empty the Dustbin.
• If the brush at the bottom of the Jet Bot is blocked by
foreign matter, turn off the power switch and remove
foreign matter from the brush.
• When noise suddenly increases, turn off the power
switch and empty the Dustbin.
The Jet Bot cannot find the Clean
Station.
• Check if there's a power failure or whether the power
plug is unplugged.
• Remove any obstacles around the Clean Station that
may prevent the Jet Bot from returning to the Clean
Station.
• When there's foreign matter on the charging terminals,
charging can be affected. Clean the foreign matter off
the terminals.
English
38
VR8500_EN_00858K-00_EU.indd 38
2021-12-01 오전 10:32:57
