SAMSUNG DCS
PROGRAMMING
TECHNICAL MANUAL
SECTION
Page 136 of 287
Updated I&M
May 2002
AA TRANS TIME:
After this time, compare input digit with AA translation table (MMC 732) and transfer to
destination.
ALERT TONE TIMER:
This timer sets the duration of the attention tone preceding a call to a keyset in the
Voice Announce or Auto Answer mode. This tone will also precede a forced Auto Answer call.
ALM REM INTERVAL:
This timer controls the time between ring attempts at a station when alarm reminder
is set.
ALM REM RING OFF:
This timer controls the length of the ring cycle duration when alarm reminder is set at
a station.
ATT RECALL TIME:
This is the length of time a transfer recall will ring at a station before recalling the
operator.
AUTO REDIAL INT:
This timer controls the time between attempts after RETRY dialling is set on a station.
AUTO REDIAL RLS:
This timer controls the duration of a Ring No Answer condition on a retry number
dialled before the auto redial is automatically cancelled.
DCS70 – BARGE IN TONE:
This timer controls the intervals between the tones sent to the keyset that is
being barged in on.
CALLBACK NO ANS:
This timer controls the time before the callback is automatically cancelled when a
callback detects Ring No Answer.
CAMP ON RECALL:
This timer controls the duration of time a camped-on call will stay at a destination
before recalling to the transferring station.
CLIP DISPLAY TIME:
The amount of time that the Calling Line ID information remains on the keyset’s
display.
CLIP MSG RECEIVE:
The amount of time that the system will allow a valid message from the CO
CLEAR CO TIME:
The length of time a DTS key remains busy after cleardown.
CO CONFIRM TIME:
After this time, the outgoing call is disconnected or you can hear the confirm tone.
CO-CO DISCONNECT:
This timer monitors the duration of a unsupervised conference; when it expires, both
trunks are disconnected.
CONFIRM TONE TIME:
The time tone confirmation is heard when a feature is activated or deactivated.
CRD TONE INT TIME (Call Recording Tone Interval Time):
This timer controls the timing of intervals
between the tones which indicates the call is recorded by Cadence.
DATA EXIT TIME :
Not used now.
DATA OTASK TIME
: Not used now.
DIAL PASS TIME
: This timer is the wait time for preventing the mis-dialling of an outgoing call. After the last
digit has been dialled, the voice path is connected.
DISA DISCONNECT:
This timer controls the maximum duration of a DISA call.
DISA LOCK OUT TIMER:
This timer controls the duration of time a DISA call is not allowed to be made after
the DISA error counter has expired (MMC 500).
