EN
6
Power Levels and Time Variations
The power level function enables you to adapt the amount of energy
dissipated and thus the time required to cook or reheat your food,
according to its type and quantity. You can choose between the power
levels below.
The cooking times given in recipes and in this booklet correspond to
the specific power level indicated.
The maximum time available per power level is shown in the table
above.
A defrosting time can be set up to 50 min. But the time is reduced to
25 min (for HIGH) or 40 min (for MEDIUM or LOW) the moment you
change the current power level (DEFROST) to other level such as
HIGH, MEDIUM or LOW.
Example: If you set a defrosting time to 45min with the heating
mode at DEFROST and if you change the power level
to HIGH, the time will be automatically reduced to
25min.
You can set the power level first and the cooking time next, and vice
versa.
Stopping the Cooking
You can stop cooking at any time so that you can:
•
Check the food
•
Turn the food over or stir it
•
Leave it to stand
If you want to cancel any cooking settings before starting cooking,
simply press
CANCEL
(
) once.
Using +30sec Pad
This is a ONE TOUCH COOK button.
By touching the button once, you can start heating instantly.
You can increase the cooking time by pressing the +30sec button
when in a heating cycle.
The cooking time increases by 30 seconds at each press on +30sec
button. But it can not exceed the maximum time allowed for the power
level selected.
Power Level
Percen-tage
Output
HIGH (
)
MEDIUM (
)
LOW (
)
HIGH DEFROST (
)
LOW DEFROST (
)
100 %
70 %
50 %
30 %
18 %
1000 W
700 W
500 W
300 W
180 W
Power Level
Max. Time
HIGH (
)
MEDIUM (
)
LOW (
)
HIGH DEFROST (
)
LOW DEFROST (
)
25 min.
40 min.
40 min.
50 min.
50 min.
To stop the cooking...
Then...
Temporarily
Open the door or press
pad once.
Result :
Cooking stops.
To resume cooking, close the door and press
again.
Completely
Press the
pad twice.
Result :
The cooking settings are
cancelled.
Before operating the oven, times can be increased/
decreased using either the timer dial or +30sec button.
During the operating, time may only be added by using the
+30sec button.
jtXWX`hwhuGl|yvTWW\\`jluUGGwG]GGm SGzG^SGYWW^GGXWaX^Ght
