ENGLISH
E-
15
Assigning Address to Indoor Unit
Before installing the indoor unit, assign an address to the indoor unit
according to the air conditioning system plan.
1
The address of the indoor unit is assigned by adjusting MAIN(SW02) and
RMC(SW04) rotary switches.
2
The MAIN address is for communication between the indoor unit and the out
door unit. Therefore, you must set it to operate the air conditioner properly.
3
It is required to set the RMC address if you install the wired remote control
ler and/or the centralized controller.
4
If you install optional accessories such as the wired remote controller, cen
tralized controller, etc. see an appropriate installation manual.
5
If an optional accessory is not installed, you do not have to set the RMC
address. However, adjust K1 and K2 switches of the SW05 DIP switch to
"ON" position in this case.
6
SW
07
SW
06
SW04 RMC
Set the MAIN address by adjusting the rotary switch(SW02) from 0 to 9.
Each indoor unit connected to the same outdoor unit must have different
address.
If an indoor unit does not have an optional accessory
and its MAIN address is "0"
7
SW02 MAIN SW04 RMC
SW
05
K1 K2 K3 K4
K5 K6 K7 K8
K9 K10 K11 K12
SW02 MAIN
SW
07
SW
06
SW
05
K1 K2 K3 K4
K5 K6 K7 K8
K9 K10 K11 K12
