Samsung ACH1800E, Руководство по обслуживанию

Страница: 40 / 150

Samsung Electronics 4-21
4-5-2 Preparing the Area for Installation
Preparing the Area for Installation of Indoor Unit
1. Measure the distance between ceiling and
ceiling wall.
2. Place the pattern sheet on the ceiling.
3. Cut the ceiling to install the indoor unit by
attaching the pattern sheet onto the ceiling.
Then cut the pattern sheet and ceiling in section
A and make a hole in the ceiling at the position
of the hook. Use the plummet to mark the
position on the ceiling wall, which is vertically
in line with the hole in the ceiling, and make
these 4 holes in the ceiling wall.
4. Insert bolt anchors, use existing ceiling supports
or construct a suitable support as shown in
figure.
5. Install the suspension bolts depending on the
ceiling type.
IMPORTANT : Ensure that the ceiling is strong enough
to support the weight of the indoor unit.
Before hanging the unit, test the strength
of each attached suspension bolt.
6. Screw eight nuts to the suspension
bolts making space for hanging the
indoor unit.
IMPORTANT : You must install the suspension bolts
more than four when installing the indoor
unit.
7. Hang the indoor unit to the suspension bolts
between two nuts.
NOTE
: ◆
Tubing must be laid and connected inside the
ceiling when suspending the unit. If the ceiling
is already constructed, lay the tubing into
position for connection to the unit before
placing the unit inside the ceiling.
8. Screw the nuts to suspend the unit. Cut a pad
stopper and place it on the bracket at this time.
Installation
Concrete
Suspension bolt(M8)-field supply
Hole in anchor
Hole in plug
Insert
Ceiling support
Pad stopper
Bracket
NOTE :
◆
Since the diagram is made of
paper, it may shrink or stretch
slightly due to temperature or
humidity. For this reason, before
drilling the holes maintain the
correct dimensions between the
markings; refer to page 2-3.
699 (Space of Suspension Bolts)
840 (Outer Dimensions)
880 (Cutting Dimension of Ceiling)
950 (Dimensions of Front Panel)
880 (Cutting Dimensions of Ceiling)
840 (Outer Dimensions)
766 (Space of Suspension Bolts)
00152-OIAIN-5 2/1/01 1:56 PM Page 4-21