Samson TROVIS SAFE 3731 Series, Руководство по эксплуатации

Страница: 26 / 104

26 EB 8389S EN
Statistical information
The 'Test information' status indicates
'Test active'.
1.
Diagnosis > Statistical information > Data
logger
−
Selection: [Permanent]
2. − Scan rate: 0.2 to 3600.0 s, [1.0 s]
3. − Start data logger
Note:
Right-click 'Stop data logger' and se-
lect ‘Execute’ to stop the data logger
('Test information' = 'Test not active').
3.2.2 Triggered data logging
Measured values are saved in a circular buf-
fer after the event defined in 'Start trigger
via' has occurred (see
u
Section 3.2.2.1 to
section 3.2.2.5). The event that has triggered
data logging is recorded. Data logging is
terminated after 100 measured values per
measured variable have been saved in the
circular buffer. The 'Scan rate' determines
the time between recordings. A 'Pre-trigger
time' greater than 0 also leads to the mea-
suring values before the triggering event for
the time selected being included in the 100
measured values per measured variable. The
'Pre-trigger time' may include the value 100
x 'Scan rate' at the maximum.
Defining parameters
1. Select 'Trigger' (Selection).
2. Select the triggering event.
3. Enter scan rate.
4. Start data logger.
The 'Test information' status indicates
'Test active'. At the end of data logging,
the progress flag reads 'Memory full,
ending measuring'.
Note:
Right-click 'Stop data logger' and se-
lect ‘Execute’ to stop the data logger
('Test information' = 'Test not active').
3.2.2.1 Triggered by condensed
state
The measured values are included in the trig-
gered data logging when the condensed
state defined in 'Start trigger via condensed
state' arises.
1.
Diagnosis > Statistical information > Data
logger
− Selection: Trigger
2. − Trigger status:
Start trigger via condensed state
− Pre-trigger time:
0.0 s to 100 x 'Scan rate', [0.0 s]
−
Trigger via condensed state: No message,
[Maintenance required], Maintenance de-
manded, Out of specification, Maintenance
alarm
3. − Scan rate: 0.2 to 3600.0 s, [1.0 s]
4. − Start data logger

