Samson 3730-4, Монтаж и эксплуатация

Страница: 6 / 212

Modifications to positioner firmware compared to the previous version
Communication
Firmware Modification
K 1.01
Internal modifications
K 1.10 The FEATURE_SELECT parameter allows you to set whether an active diagnostic func-
tion is to be reported by a GOOD_FUNCTION_CHECK or a BAD_FUNCTION_
CHECK (see page 144)
K 1.11 – More trigger conditions in the data logger (see page 142)
– More additional functions (FEATURE_SELECT) (see page 144)
– The limits of the discrete valve position (POS_D_LIMIT_LOW, POS_D_LIMIT_UP) can
now be defined as required (see page 86)
K 1.12 Resetting the identification parameters resets all the parameters saved in the controller.
The parameters saved in the controller are, however, not reset when just the start-up
parameters are reset (see page 134).
K 1.13
Internal modifications
K 1.15 Feature of ID number adaptation acc. to PROFIBUS PA Profile 3.02 added. It allows a
Type 3785 Positioner (Profile 2.0 and Profile 3.0) to be directly replaced with a
Type 3730-4 Positioner in the compatability mode (see page 87).
K 1.16
The function to suppress extended diagnostic messages allows messages for the
PROFIBUS diagnosis protocol to be suppressed. The messages are still included in the
condensed state according to their classification. The parameter to suppress the
diagnositic messages exists in the following integrations:
DD:
2.2.007
TROVIS-VIEW: 3.60.005 (device module) and higher
DTM:
1.3.0.1
K 1.17 The versions K1.12 to K1.16 do not save a reference variable received in acyclic data
exchange as the valid value for the fail-safe action 'Last valid setpoint is used'. In the
affected modules for data exchange, the polling for a valid reference variable has
been changed to GOOD_NON_SPECIFIC.
Communication
Firmware Modification
R 1.43 to
R 1.46
Internal modifications
6
EB 8384-4 EN
Modifications to positioner firmware compared to the previous version