Samson 3730-4, Монтаж и эксплуатация

Страница: 175 / 212

EB 8384-4 EN
175
AO Transducer Block, Slot 1 · Manufacturer-specific parameters Appendix
Description
Used to select the type of initilization
Direction of operation, i.e. how the reference variable w is assigned to the controlled variable x
Indicates the number of zero point calibrations since the last initialization.
This pin position needs to be entered for initialization in NOM or SUb operating modes.
The follower pin must be place in the correct pin position depending on the valve travel/rotational angle. Refer to
Table Code 4, on page 114.
Used to enter the pressure limit (Code 16).
Information on any initialization errors
Allows the valve to be moved to its actual fail-safe position over the bus. The positioner remains, however, still in
AUTO mode. Fail-safe position is indicated by an S blinking on the display.
Note:
An S blinking on the display also indicates an invalid setpoint (bad status).
Activate/deactivate the final position when w falls belows the adjusted valve.
Activate/deactivate the final position when w exceeds the adjusted valve.
This parameter is determined during initialization and indicates the position of the slide switch (AIR TO
OPEN/CLOSE). The positioner needs to be re-initialized when the switch position is changed.
Contains parameters for static characteristic test (d3) which can be read and written.
0. . Start
1. . End
2. . Waiting time after step
3. . Number of measurements until return
Indicates the status of the solenoid valve (Code 45).