Samson 3730-4, Монтаж и эксплуатация

Страница: 117 / 212

Code
no.
Parameter – Display, values
[default setting]
Description
Important ! Codes with marked with an asterisk (*) must be enabled with Code 3 prior to configuration.
36* Reset
[OFF], RUN, ESC
Resets all parameters to default (factory setting).
Note: After setting RUN , the positioner must be re-initialized.
38* Inductive alarm
[NO], YES, ESC
Indicates whether the inductive limit switch option is installed or
not.
39 System deviation e info
–99.9 to 999.9 %
Display only,
indicates the deviation from the position required.
40
Transit time Open info
0 to 240 s [0]
Display only,
minimum opening time determined during initialization.
41
Transit time Closed info
0 to 240 s [0]
Display only,
minimum closing time determined during initialization.
42
Auto-w/Man-w info
0.0 to 100.0 % of the span
Display only,
Auto mode: indicates the supplied automatic reference variable
Man mode: indicates the supplied manual reference variable
43 Firmware info
Control Display only,
indicates the positioner type and the current firmware version in
alternating sequence.
44
y info
[0] to 100 %
0P, MAX, – – –
Display only.
Indicates the control signal y in % based on the travel range de-
termined on initialization
MAX: The positioner builds up its maximum output pressure, see
description in Code 14 and 15.
0P: The positioner vents completely, see description in Code 14
and 15.
– – –: The positioner is not initialized.
45
Solenoid valve info
YES, HIGH/LOW, NO
Display only,
indicates whether a solenoid valve is installed or not.
If a voltage supply is connected at the terminals of the installed
solenoid valve,
YES and HIGH appear on the display in alternat-
ing sequence. If a voltage supply is not connected (actuator
vented, fail-safe position indicated on the display by the S sym-
bol),
YES and LOW appear on the display in alternating se-
quence.
EB 8384-4 EN
117
Appendix