Samson 3730-4, Монтаж и эксплуатация

Страница: 133 / 212

EB 8384-4 EN
133
Physical Block, Slot 0 · Profile-specific parameters Appendix
Description
Type of alarm Description
. . . .
DIA_MAINTENANCE_DEMANDED
. . . . . . . .
. . . . . . . . .
. . . . . . . .
. . . R A device error exists
. . . R Maintenance demanded
. . . R Device performing a function check or it is in simulation or in MODE_LO
. . . R The current process conditions do not allow a valid calculation of values.
Further diagnostic information available, refer to DIAGNOSIS_EXT/DIAGNOSIS_EXTENSION_2 parameters
Further detailed information of the device, bitwise coded. More than one alarm possible at once.
Byte Bit Description Byte Bit Description
51)
2 0 x signal (Code 62)
2 1 i/p converter (Code 64)
2 2 Hardware error (Code 65)
2 3 Control parameter error (Code 68)
2 4 Potentiom. parameter error (Code 69)
2 5 Calibration (Code 70)
2 6 No production calibration
2 7 General parameters (Code 71)
3 0 Emergency mode · No error
(Code 76)
3 1 Program loading error (Code 77)
3 2 Options parameter (Code 78)
3 3 Info parameter (Code 75)
3 4 Data memory (Code 66)
3 5 Test calculation (Code 67)
3 6 PA parameters (Code 74)
3 7 Diagnostic parameters (Code 80)
4 0 Reset: Communication controller
4 1 Reset: Bus link error alarm
4 2 Bin2 deactivated
4 3 Reset: Control controller
4 4 –
4 5 –
4 6 –
4 7 –
5 0 Supply air: Perhaps modified (TEST)
5 1 Supply air: Perhaps insufficient (TEST)
5 2 Supply air: Perhaps insufficient
5 3 Supply air: At full capacity
5 4 Supply air: At full capacity (TEST)
5 5 Supply air: Perhaps modified
5 6 Actuator springs: Spring stiffness
reduced (TEST)
5 7 Actuator springs: Pre-tensioning
reduced (TEST)
Defines the availability of the status bit in DIAGNOSIS parameter
Defines the availability of the status bit in DIAGNOSIS_EXT parameter