Samson 3730-4, Монтаж и эксплуатация

Страница: 144 / 212

144
EB 8384-4 EN
Appendix Physical Block, Slot 0 · Manufacturer-specific parameters
ET_BSZ 78 r Element Parameter name Statistical information AUTO: Structure for end position trend – operating hours counter
0 MESSWERT_0
…
29
MESSWERT_29
30 REFERENZWERT
ET_ENDLAGE 79 r Element Parameter name Statistical information AUTO: Structure for end position trend – drive signal
0 MESSWERT_0
…
29
MESSWERT_29
30 REFERENZWERT
ET_VENTILSTELLUNG 77 r Element Parameter name Statistical information AUTO: Structure for end position trend – valve position x
0 MESSWERT_0
…
29
MESSWERT_29
30 REFERENZWERT
FEATURE_SELECT 64 S r/w ALL Bit:
0 = false · 1 = true Coded bitwise, therefore several alarms at the same time possible
Byte Bit
0
0 BAD_DEVICE_FAILURE sets . . . . . .
DIAG_EXT bit By selecting “DIA_MAINTENANCE_ALARM sets DIAG_EXT bit“, the DIAG.ext bit (Octet 1) is set on using the
profile extension “Condensed status and diagnostic messages“ when a fault or the corresponding diagnostic
alarm DIA_MAINTENANCE_ALARM is detected by the positioner.
C
p
0 1 Test function activated . . . . . . . . . . The activation of this function allows errors to be simulated in TROVIS-VIEW (Positioner (AO, TRD) folder (> Si
mulation) (
0 2 LO and active diagnostic function. .
set GOOD_FUNCTION_CHECK During a diagnosis test, the Profile indicated that a BAD_FUNCTION_CHECK has been set. This can be preven
ted by activating this additional function to actually set a BAD_FUNCTION_CHECK. (
K 1.11 and higher)
0 3 Use DP standard diagnosis . . . . . .
(6 bytes) Select whether the positioner responds to a GET_DIAG telegram with the full diagnosis (14 using as Profile or 26
as manufacturer specification) or only with 6 bytes for DP standard diagnosis (
and higher)
HISTOGRAMM_E_KURZ
70
r Element Parameter name Statistical information AUTO: Structure for short-term histogram plotting e
0 E_INTERVAL_VALUE_0
…
11
E_INTERVAL_VALUE_11
12 E_AVERAGE
0
…
11
12